top of page

Equipment developed to facilitate the process of removing and tightening the nut of the spring beam fixing clamp.

With its resized and reformulated system, it allows a greater approximation of the wheel due to its smaller transmission box than the old one. The tightening control is performed through the impulse given by an electric wrench, not damaging the thread and not heating the nut, clamp or screw. No need to retighten and speed up the process.

Technical characteristics:

Three-Phase Supply Voltage: 220 Volts or 380 Volts

Electric Motor: 3CV

Electric Drive: 30A reversing electric switch with lever

Reduction System: Reducer with bronze crown and endless

Output Rotation: 38 RPM

Socket Fit: 3/4 ”or 1” (Inch)

Output Torque (Socket): 80 Kgf / m

Length (mm): 1468

Width (mm): 481

Height (mm): 278

Weight (Kg): 113 Kg


bottom of page